WP356138 Whirlpool Hose Clamp
Refrigerator ICEMAKER MICRO SWITCH 16802 by SUPCO
125 Volt 1/4 Amp 350V
125 Volt 1/4 Amp 350V
Weight : 0.076500 lbs
Dimension : 4.921200 x 3.661400 x 0.590500
Product Details
Reviews
Replaces Parts
Installation Instructions
Compatible Models
Compatible Brands
Refrigerator ICEMAKER MICRO SWITCH 16802 by SUPCO
125 Volt 1/4 Amp 350V
125 Volt 1/4 Amp 350V
Weight : 0.076500 lbs
Dimension : 4.921200 x 3.661400 x 0.590500
Write Your Own Review
The following parts are replaced by this product
- 356138
- 10100
- 11123
- 12768
- 16315
- 16410
- 17576
- 272856
- 353095
- 52269
- 660634
Replacing a WP356138 Whirlpool Hose Clamp
1. Unplug the appliance from the power source and shut off the water going to the appliance.
2. Locate and remove the existing hose clamp by unscrewing it with a pair of pliers.
3. Measure the circumference of the hose where the clamp will be installed so you can purchase the correct size clamp.
4. Purchase a new WP356138 Whirlpool hose clamp.
5. Place the new hose clamp in position on the hose so the screw openings are facing away from the hose.
6. Gently tighten the screw using a flathead screwdriver until the clamp is secure on the hose.
7. Plug in the appliance and turn on the water supply to the appliance.
8. Test for any leaks around the hose clamp and make sure it is secure.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
1. Unplug the appliance from the power source and shut off the water going to the appliance.
2. Locate and remove the existing hose clamp by unscrewing it with a pair of pliers.
3. Measure the circumference of the hose where the clamp will be installed so you can purchase the correct size clamp.
4. Purchase a new WP356138 Whirlpool hose clamp.
5. Place the new hose clamp in position on the hose so the screw openings are facing away from the hose.
6. Gently tighten the screw using a flathead screwdriver until the clamp is secure on the hose.
7. Plug in the appliance and turn on the water supply to the appliance.
8. Test for any leaks around the hose clamp and make sure it is secure.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
