205241 Speed Queen Pressure Bulb Assembly

How to Replace the Speed Queen 205241 Assy Pressure Bulb

1. Unplug the washing machine from the wall outlet. Make sure the power cord is disconnected from the outlet before doing any repairs.

2. Remove the back panel screws and remove the panel. There should be several screws located around the back of the washer.

3. Locate the pressure bulb assembly. It will be on the right side of the tub. The pressure bulb assembly consists of a hose and a rubber bladder.

4. Disconnect the hose from the pressure bulb assembly. Use pliers or a wrench to loosen the fitting if necessary.

5. Remove the old pressure bulb assembly by unscrewing the two screws that hold it in place.

6. Install the new pressure bulb assembly by sliding it into the same place from where the previous one was removed.

7. Reconnect the hose to the pressure bulb assembly. Make sure the connection is secure.

8. Replace the back panel, screws, and plug the washer back in.

9. Test the washer to make sure the pressure bulb assembly is functioning correctly.

Congratulations! You have successfully replaced the Speed Queen 205241 Assy Pressure Bulb.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.