W11171119 Whirlpool Radiant Surface Element

DIY Guide to Replacing the Whirlpool W11171119 ELMNT-SURF in Your Whirlpool Dryer

Replacing the Whirlpool W11171119 ELMNT-SURF in your Whirlpool dryer can be a daunting task, but with the right steps and proper safety precautions, you can do it yourself. This guide will take you through all the necessary steps for successfully replacing the part in your own home.

Step 1: Unplug the power cord from the wall outlet. Before you start any repairs, disconnecting the power is the most important safety measure.

Step 2: Access the back of the dryer. Once the power has been disconnected, you can release the screws that secure the control console and access the back panel of the dryer.

Step 3: Disconnect the wiring harness. Disconnect all the wires that are attached to the old part before you pull it out. This will ensure that you don’t damage the new ELMNT-SURF once it is installed.

Step 4: Install the new part. Gently slide the new part in place, making sure all the connectors line up correctly.

Step 5: Secure the wiring harness. Reattach all the wires you disconnected in step 3 and make sure they are firmly secured.

Step 6: Reinstall the control console. Replace the screws and make sure everything is tightly secured.

Step 7: Test the new part. Replug the power cord into the wall outlet and turn the power back on. Then turn on the dryer and check to make sure the new ELMNT-SURF is working correctly.

By following these steps, you should be able to replace the Whirlpool W11171119 ELMNT-SURF in your Whirlpool dryer without any problems. Remember to always exercise caution when doing any type of repairs or maintenance on your dryer.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.