D510213 Speed Queen Sensor

Replacing the Speed Queen D510213 SENSOR DIY Instructions

Tools needed:

-Phillips screwdriver
-Flat-head screwdriver
-Needle-nose pliers

Step 1: Unplug the machine from its power source.

Step 2: Remove the front and back panels of the machine by using a Phillips screwdriver to loosen and remove the screws.

Step 3: Locate the Speed Queen D510213 SENSOR. This is usually found at the back of the washer, near the bottom.

Step 4: Disconnect any wiring connected to the sensor by using needle-nose pliers.

Step 5: Unscrew the old sensor from the machine using a flat-head screwdriver.

Step 6: Install the new sensor and then connect the wiring.

Step 7: Tighten the screws to secure the new sensor in place.

Step 8: Reattach the front and back panels of the machine and then plug it back into the power source.

Your Speed Queen D510213 SENSOR has been successfully replaced!

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.