39508P Speed Queen KIT,Drive BELL & SEAL

1. Start by turning off the power supply to the Speed Queen 39508P washing machine. Disconnect the water supply line from the back of the washing machine before pulling it out from its current location.

2. Unplug the power cord from the wall outlet and then remove the top panel of the washing machine.

3. Carefully inspect the drive bell for any signs of damage or wear and tear. If the drive bell is damaged, replace it with a new one.

4. Once the drive bell is replaced, you will need to remove the old seal. Use a flat screwdriver to carefully pry the seal away from the drive bell.

5. Clean the gap between the hub of the drive bell and the tub of the washing machine using a damp cloth. This will ensure proper sealing when the new seal is installed.

6. Place the new seal around the hub of the drive bell and use a flat screwdriver to press the seal firmly into place.

7. Replace the top panel of the washing machine and plug the power cord back into the wall outlet. Reconnect the water supply line to the back of the washing machine.

8. Turn on the power supply to the washing machine and test the new seal by running a cycle. Make sure that no water leaks out of the washing machine.

By following these simple steps, you can easily replace the Speed Queen 39508P KIT, DRIVE BELL & SEAL. Making sure to replace any damaged components will help to keep your washing machine in good working order.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.