801434W Speed Queen Push-To-Start Switch
801434W Speed Queen Push-To-Start Switch
Weight : 0.000000 lbs
801434W Speed Queen Push-To-Start Switch
Weight : 0.000000 lbs
Write Your Own Review
1. Begin by gathering the necessary tools and materials you will need to replace the Speed Queen 801434W SWITCH, PUSH-TO-START. These include a replacement switch, a Phillips head screwdriver, wire cutters, and needle-nose pliers.
2. Unplug the washing machine from its power source and turn off the water supply.
3. Remove the control panel of the washing machine to access the switch. Use the Phillips head screwdriver to unscrew the fasteners holding the control panel in place.
4. Once the control panel is removed, identify the defective switch that needs to be replaced.
5. Cut any wires that are connected to the defective switch using the wire cutters.
6. Remove the defective switch by pulling it out of its socket with the needle-nose pliers.
7. Insert the new switch into the open socket and secure it with the Phillips screws. Make sure the switch is firmly seated in the socket.
8. Reconnect any wires that were disconnected from the defective switch to the new switch, making sure the wires are securely attached.
9. Reassemble the control panel and secure it with the Phillips screws.
10. Plug the washing machine back into its power source and turn on the water supply. Test the switch to make sure it is working properly.
11. Clean up any debris generated from the repair.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
2. Unplug the washing machine from its power source and turn off the water supply.
3. Remove the control panel of the washing machine to access the switch. Use the Phillips head screwdriver to unscrew the fasteners holding the control panel in place.
4. Once the control panel is removed, identify the defective switch that needs to be replaced.
5. Cut any wires that are connected to the defective switch using the wire cutters.
6. Remove the defective switch by pulling it out of its socket with the needle-nose pliers.
7. Insert the new switch into the open socket and secure it with the Phillips screws. Make sure the switch is firmly seated in the socket.
8. Reconnect any wires that were disconnected from the defective switch to the new switch, making sure the wires are securely attached.
9. Reassemble the control panel and secure it with the Phillips screws.
10. Plug the washing machine back into its power source and turn on the water supply. Test the switch to make sure it is working properly.
11. Clean up any debris generated from the repair.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
