204870 Speed Queen Front Panel Kit with Pads

Replacing the Speed Queen 204870 KIT, PANEL FRNT W/PADS

Are you looking to replace the Speed Queen 204870 KIT, PANEL FRNT W/PADS but don’t know how? Look no further – below you will find step-by-step instructions on how to easily and efficiently replace this part.

Tools Required:

-Screwdriver

-Socket wrench

Step-by-Step Instructions:

1. Unplug the washer from the power outlet and turn off the water supply.

2. Remove the top panel of the washer by unscrewing the screws located at the back.

3. Remove the screws and/or clips that hold the front panel in place.

4. Carefully take out the front panel and place aside.

5. Disconnect any wiring attached to the Speed Queen 204870 KIT, PANEL FRNT W/PADS and remove the part.

6. Take the new part and connect any wiring as required.

7. Place the new part where the old one was and secure it with screws and/or clips.

8. Place the top panel back on and secure with screws.

9. Turn on the water supply and plug back in the washer.

And there you have it! With these easy steps, you have successfully replaced the Speed Queen 204870 KIT, PANEL FRNT W/PADS in no time.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.