WB17T10011 GE Oven Terminal Block

Replacing the WB17T10011 GE Terminal Block

Overview

A terminal block is a type of electrical connector that connects multiple wires to one another and/or to other elements in an electrical system. The WB17T10011 GE Terminal Block is an electrical component used in several models of GE-branded electric ovens, stoves and ranges that may need replacement when worn or corroded. Replacing the terminal block requires some electrical knowledge and experience in working with electrical components.

Tools and Materials Needed

• Screwdriver

• Pliers

• WB17T10011 GE Terminal Block

Instructions

Step 1: Shut off power to the oven from your circuit breaker box by flipping off the switch that corresponds to the oven.

Step 2: Remove the exterior cover of the oven using a screwdriver if necessary.

Step 3: Use a pair of pliers to disconnect any wires connected to the old terminal block.

Step 4: Carefully remove the old terminal block and discard it properly.

Step 5: Insert the new WB17T10011 GE Terminal Block into the oven, making sure the connections line up correctly.

Step 6: Secure the terminal block by tightening the screws with the screwdriver.

Step 7: Reconnect the wires that were previously disconnected, making sure you match them correctly.

Step 8: Replace the exterior oven cover and turn on the power to the oven from the circuit breaker box.

Conclusion

You have just replaced the WB17T10011 GE Terminal Block. Depending on the model of your oven, the instructions may be slightly different. If you have any further questions, please refer to your owner’s manual or contact a qualified appliance technician. Be sure to unplug the appliance before servicing.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.