D511711 Speed Queen Temperature Selector Switch

DIY Instructions for Replacing Speed Queen D511711 SWITCH, TEMPERATURE SELECTOR (60HZ)

1. Unplug the Speed Queen dryer from the wall outlet.

2. Open the top panel of the dryer and locate the temperature selector switch. The selector switch is usually near the lint filter.

3. Disconnect the wiring from the temperature selector switch. Note which wire goes to each terminal on the switch.

4. Remove the mounting screws that hold the switch in place.

5. Remove the defective temperature selector switch and install the new one in its place.

6. Connect the wiring to the terminals on the new switch according to the notes you made in step 3.

7. Replace the mounting screws and tighten them securely.

8. Close the top panel of the dryer and plug it into the wall outlet.

9. Test the new temperature selector switch to make sure it works properly.

Following these instructions will help you replace your Speed Queen D511711 SWITCH,TEMPERATURE SELECTOR (60HZ) with ease. Remember to always unplug the dryer before attempting any repairs or maintenance.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.