203843 Speed Queen Water Pressure Sensor 0-400mm H2O

Step 1: Gather the necessary tools and parts required to replace the Speed Queen 203843 SENSOR,PRESSURE(0-400mm H20). Make sure you have a Phillips screwdriver, flathead screwdriver, and new replacement sensor.

Step 2: Unplug the machine. Unscrew the back panel of the washer using a Phillips screwdriver.

Step 3: Locate the old sensor and disconnect it from the washer. Usually, it will be towards the bottom of the machine and connected to the water pump.

Step 4: Remove the old sensor from the clamp and discard it.

Step 5: Install the new sensor in the same position as the old one. Make sure it is firmly clamped in place.

Step 6: Connect the wiring harness to the new sensor.

Step 7: Reconnect the back panel of the washer and plug the machine back in.

Step 8: Test the washer to make sure the new sensor is working properly.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.