WP61006074 Whirlpool Control Knob

Replacing the Whirlpool WP61006074 KNOB-CONT: A Step-By-Step DIY Guide

Are you looking to replace the Whirlpool WP61006074 KNOB-CONT? If so, you've come to the right place! Replacing this knob is a relatively easy task that anyone can do if they have just a few simple tools. Here's a step-by-step DIY guide on how to replace the Whirlpool WP61006074 KNOB-CONT.

Step 1: Gather Your Materials

Before you start the replacement process, it's important to make sure you have all of the necessary materials. You'll need:

•A new Whirlpool WP61006074 KNOB-CONT
•A Phillips head screwdriver
•A flathead screwdriver

Step 2: Remove the Old Knob

Next, you'll need to remove the old knob. Unscrew the two screws on the back of the knob with the Phillips head screwdriver and set them aside. Then, use a flathead screwdriver to gently pry the knob off the control panel.

Step 3: Install the New Knob

Once the old knob has been removed, take the new Whirlpool WP61006074 KNOB-CONT and align it with the control panel. Secure it in place by tightening the two screws you previously removed.

Step 4: Test the New Knob

The last step is to test the new knob. Turn it to different settings and make sure it's working properly. Once you've tested it, the replacement process is complete and you're good to go.

Congrats, you've successfully replaced the Whirlpool WP61006074 KNOB-CONT! This DIY replacement process should only take a few minutes to complete and requires minimal tools and materials. Best of luck with your project!

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.