WB17T10006 GE Oven Burner Receptacle Block Kit

Replacing Your WB17T10006 GE Burner Receptacle Block Kit

Are you in need of replacing your WB17T10006 GE Burner Receptacle Block Kit? The following instructions will help you do it yourself, safely and efficiently.

1. Safety First: Before beginning any installation, make sure you turn off the power to the stove at the breaker. This is essential for safety.

2. Collect Tools: You'll need a small flathead screwdriver, a Phillips head screwdriver, needle nose pliers, and a voltage meter.

3. Remove the Burner and Receptacle Block: Start by unplugging the burner from the receptacle block. Then use the flathead screwdriver and Phillips head screwdriver to unscrew the two screws on the existing receptacle block. Disconnect all of the wirings, then gently remove the block.

4. Install the New Receptacle Block: Peel off the adhesive backing on the new receptacle and carefully place it into position. Gently secure the block with the screws. Reconnect all of the wires along with the grooved, curved, and straight spade connectors. Make sure that they are properly connected so as to avoid any potential issues.

5. Test the Unit: After the block is installed and secured, plug the burner cord back into the receptacle. Turn the power back on and inspect the unit for functionality with a voltage meter.

6. Finished: Once it's been tested, you have finally replaced the WB17T10006 GE Burner Receptacle Block Kit.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.