241786008 Frigidaire Refrigerator Gasket
This is a genuine OEM part that works for some models of Frigidaire, Electrolux, Gibson, Kelvinator, Westinghouse, Crosley, Kenmore, and Tappan models.
Weight : 0.000000 lbs
Product Details
Reviews
Replaces Parts
Installation Instructions
Compatible Models
Compatible Brands
This is a genuine OEM part that works for some models of Frigidaire, Electrolux, Gibson, Kelvinator, Westinghouse, Crosley, Kenmore, and Tappan models.
Weight : 0.000000 lbs
Write Your Own Review
The following parts are replaced by this product
- 240390608
- 5304439534
- 5304448630
- 241674808
- 241569808
Replacing the Whirlpool 2306996 GASKET-FIP
1. Disconnect the power to the appliance: turn off the power switch or unplug the electrical cord from the wall outlet.
2. Turn off the gas valve, typically located near the bottom of the appliance.
3. Open up the appliance and locate the Gasket-FIP.
4. Remove any screws holding the gasket in place and carefully remove the old gasket.
5. Make sure the mounting surface is clean and dry before applying a thin coat of plumbers’ putty if desired.
6. Place the new Gasket-FIP into the area, being careful not to over tighten the mounting screws.
7. Replace any insulation that may have been removed during the process.
8. Turn on the gas valve and then turn on the power to the appliance.
9. Test the connection to make sure it is secure.
10. Finally, test the appliance for proper operation.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
1. Disconnect the power to the appliance: turn off the power switch or unplug the electrical cord from the wall outlet.
2. Turn off the gas valve, typically located near the bottom of the appliance.
3. Open up the appliance and locate the Gasket-FIP.
4. Remove any screws holding the gasket in place and carefully remove the old gasket.
5. Make sure the mounting surface is clean and dry before applying a thin coat of plumbers’ putty if desired.
6. Place the new Gasket-FIP into the area, being careful not to over tighten the mounting screws.
7. Replace any insulation that may have been removed during the process.
8. Turn on the gas valve and then turn on the power to the appliance.
9. Test the connection to make sure it is secure.
10. Finally, test the appliance for proper operation.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
