WB02T10025 GE Oven Support Bracket
This durable GE WB02T10025 Rod Support was designed with convenience in mind. We're your #1 source for genuine OEM appliance parts. Contact us for further questions as well as any other appliance parts needs!
Weight : 0.0957 lbs
Dimension : 14 x 9.5 x 0.1
This durable GE WB02T10025 Rod Support was designed with convenience in mind. We're your #1 source for genuine OEM appliance parts. Contact us for further questions as well as any other appliance parts needs!
Weight : 0.0957 lbs
Dimension : 14 x 9.5 x 0.1
Write Your Own Review
How to Replace the GE WB02T10025 Rod Support
If you have a GE oven, range, or stove with a WB02T10025 Rod Support that needs to be replaced, here's a simple guide for replacing it.
Tools Needed:
-Phillips screwdriver
-Socket wrench set
-Replacement GE WB02T10025 Rod Support
Steps:
1. Unplug the appliance or disconnect it from the power source.
2. Remove the drawer below the oven. Use a Phillips screwdriver to remove the screws holding it in place and carefully slide the drawer out of the way.
3. Locate the WB02T10025 Rod Support assembly. It's typically attached to the back wall of the oven, just behind the door.
4. Use a socket wrench to remove the bolts that hold the Rod Support in place.
5. Carefully lift the old Rod Support out of the oven, taking care to not damage any wires attached to it.
6. Insert the new WB02T10025 Rod Support into the oven and use the socket wrench to reattach the bolts.
7. Replace the drawer and screws.
8. Plug the oven back in or reconnect to the power source.
Your GE oven is now ready to use with the new Rod Support. With these DIY instructions, you can easily replace the WB02T10025 Rod Support on your own.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
If you have a GE oven, range, or stove with a WB02T10025 Rod Support that needs to be replaced, here's a simple guide for replacing it.
Tools Needed:
-Phillips screwdriver
-Socket wrench set
-Replacement GE WB02T10025 Rod Support
Steps:
1. Unplug the appliance or disconnect it from the power source.
2. Remove the drawer below the oven. Use a Phillips screwdriver to remove the screws holding it in place and carefully slide the drawer out of the way.
3. Locate the WB02T10025 Rod Support assembly. It's typically attached to the back wall of the oven, just behind the door.
4. Use a socket wrench to remove the bolts that hold the Rod Support in place.
5. Carefully lift the old Rod Support out of the oven, taking care to not damage any wires attached to it.
6. Insert the new WB02T10025 Rod Support into the oven and use the socket wrench to reattach the bolts.
7. Replace the drawer and screws.
8. Plug the oven back in or reconnect to the power source.
Your GE oven is now ready to use with the new Rod Support. With these DIY instructions, you can easily replace the WB02T10025 Rod Support on your own.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
