WPW10114608 Whirlpool Drain Hose
This Washer Drain Hose carries used water from the washer to your house drain. To access the part, remove the back panel of your washer, then the lower front access panel. When disconnecting any hoses, place a towel down to catch any water. You'll need to transfer over the old clamps to the new hose.
Weight : 8.820400 lbs
Dimension : 22.283400 x 18.149600 x 3.031400
Product Details
Reviews
Replaces Parts
Installation Instructions
Compatible Models
Compatible Brands
This Washer Drain Hose carries used water from the washer to your house drain. To access the part, remove the back panel of your washer, then the lower front access panel. When disconnecting any hoses, place a towel down to catch any water. You'll need to transfer over the old clamps to the new hose.
Weight : 8.820400 lbs
Dimension : 22.283400 x 18.149600 x 3.031400
Write Your Own Review
The following parts are replaced by this product
- 8540011
- W10114608
- W10225577
Replacing the WPW10114608 Whirlpool Drain Hose
Tools Needed:
-Screwdriver
-New WPW10114608 Whirlpool Drain Hose
Instructions:
1. Locate and unplug the power cord from your Whirlpool dishwasher.
2. Open the dishwasher door to locate the drain hose that needs to be replaced.
3. Use a screwdriver to loosen the clamp that holds the old drain hose in place.
4. Carefully remove the old drain hose and discard it.
5. Insert the new WPW10114608 Whirlpool Drain Hose into the same location as the old hose.
6. Secure the new drain hose in place by re-tightening the clamp with the screwdriver.
7. Plug in the power cord back into the dishwasher and close the door.
8. Turn on the dishwasher to check if the new hose is functioning properly.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Tools Needed:
-Screwdriver
-New WPW10114608 Whirlpool Drain Hose
Instructions:
1. Locate and unplug the power cord from your Whirlpool dishwasher.
2. Open the dishwasher door to locate the drain hose that needs to be replaced.
3. Use a screwdriver to loosen the clamp that holds the old drain hose in place.
4. Carefully remove the old drain hose and discard it.
5. Insert the new WPW10114608 Whirlpool Drain Hose into the same location as the old hose.
6. Secure the new drain hose in place by re-tightening the clamp with the screwdriver.
7. Plug in the power cord back into the dishwasher and close the door.
8. Turn on the dishwasher to check if the new hose is functioning properly.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
No more associated models for this part.
