285825 Whirlpool Washer Agitator Cam Repair Kit
285825 Whirlpool Washer Agitator Cam Repair Kit
Weight : 0.431700 lbs
Dimension : 5.000000 x 4.000000 x 2.750000
285825 Whirlpool Washer Agitator Cam Repair Kit
Weight : 0.431700 lbs
Dimension : 5.000000 x 4.000000 x 2.750000
Write Your Own Review
Replacing the Whirlpool 285825 CAM-AGITATOR
1. Unplug your washing machine power cord from the wall socket to avoid any electrical shock or injury.
2. Remove the front panel of the washing machine. Depending on your washing machine model, this could require removing screws or just popping off the top panel.
3. Locate the agitator. It should be in the center of the washing machine and have a white plastic cam attached to it.
4. Use a pair of pliers to remove the clip that holds the cam in place. Carefully lift the cam away from the agitator and set aside.
5. Now, take the new cam and insert it into the hole in the center of the agitator. Make sure it is securely seated before proceeding.
6. Place the clip back over the cam and use the pliers to tighten it down.
7. Reattach the washing machine’s front panel and plug back in the power cord.
8. Run a test cycle to check that the new cam is functioning correctly.
Congratulations! You’ve just replaced the Whirlpool 285825 CAM-AGITATOR.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
1. Unplug your washing machine power cord from the wall socket to avoid any electrical shock or injury.
2. Remove the front panel of the washing machine. Depending on your washing machine model, this could require removing screws or just popping off the top panel.
3. Locate the agitator. It should be in the center of the washing machine and have a white plastic cam attached to it.
4. Use a pair of pliers to remove the clip that holds the cam in place. Carefully lift the cam away from the agitator and set aside.
5. Now, take the new cam and insert it into the hole in the center of the agitator. Make sure it is securely seated before proceeding.
6. Place the clip back over the cam and use the pliers to tighten it down.
7. Reattach the washing machine’s front panel and plug back in the power cord.
8. Run a test cycle to check that the new cam is functioning correctly.
Congratulations! You’ve just replaced the Whirlpool 285825 CAM-AGITATOR.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
No more associated models for this part.
