WD19X25187 GE Dishwasher Single Speed Drain Pump Kit

DIY Guide to Replacing the GE Dishwasher Single Speed Drain Pump Kit (WD19X25187)

Introduction

The drain pump of your GE dishwasher is responsible for draining water from the unit. If the pump isn't working properly, your dishwasher won't be able to remove water from the basin. Fortunately, it's possible to replace the pump yourself in just a few simple steps with the proper tools and parts. This DIY guide will show you how to replace your GE dishwasher's single-speed drain pump kit (WD19X25187).

Tools Needed:

• Multi-bit Screwdriver

• Pliers

• Bucket

• WD19X25187 Single Speed Drain Pump Kit

Instructions

1. Unplug Your Dishwasher. Before you begin, make sure to unplug the power cord of your dishwasher from the wall outlet. This will prevent any electric shock while working with the Wiring.

2. Disconnect Wiring. Next, disconnect the Wiring that runs between the control panel and the motor by gently pulling the wires off the motor.

3. Remove Old Pump. Use a multi-bit screwdriver to remove the screws holding the old pump in place. Once the screws have been removed, carefully lift the pump out of the housing and set it aside.

4. Install New Pump. Insert the new pump into the pump housing, ensuring the O-ring is properly in place. Secure the new pump in place with the multi-bit screwdriver.

5. Reconnect Wiring. Reconnect the Wiring between the control panel and motor with the pliers.

6. Test New Pump. Finally, plug in your dishwasher and run a cycle to make sure the new pump is working properly.

Replacing the GE dishwasher single-speed drain pump kit (WD19X25187) is a simple process that requires just a few tools and parts.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.