56095P Speed Queen Dryer Drum Drive Belt

Step 1: Unplug the Dryer

Before starting any repair, always make sure to unplug the dryer from the electrical outlet. It is also a good practice to turn off its gas supply, if applicable.

Step 2: Remove Top Panel and Front Panel

Locate the front panel and top panel of the dryer. Depending on your model, there may be screws or snaps that need to be removed in order to remove these panels. Remove them carefully and set aside.

Step 3: Disconnect Dryer Drum From Motor Pulley

Locate the drive belt and ensure it is not broken or frayed. If it is, you will need to replace it. To do this, locate the motor pulley and disconnect the belt from it.

Step 4: Remove Old Drive Belt

Carefully pull the old drive belt off of the dryer drum and discard it.

Step 5: Feed New Drive Belt Through Drum and Motor Pulley

Feed the new drive belt through the dryer drum and motor pulley, making sure the belt is properly aligned.

Step 6: Replace Front Panel and Top Panel

Replace the front and top panels, ensuring that all screws are properly tightened and that all snaps are in place.

Step 7: Plug In Dryer and Test Drive Belt

Finally, plug the dryer back into the electrical outlet and test the drive belt to make sure it is working properly. If all is working correctly, you’re done!

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.