WR60X10307 GE Refrigerator Evaporator Fan Motor

DIY Instructions to Replace the WR60X10307 GE Refrigerator Evaporator Fan Motor

1. Begin by unplugging your refrigerator from the wall socket and turning off any valves connected to the appliance.

2. Ensure that the refrigerator is empty before beginning repair work.

3. Locate the evaporator fan motor, which is typically located in the freezer compartment of the refrigerator. It is usually mounted on a bracket near the evaporator coils.

4. Unscrew and remove the screws that are holding the fan motor in place.

5. Disconnect the old evaporator fan motor’s wires.This can sometimes be done by hand. If it is harder to remove, use a pair of pliers to disconnect them.

6. Take the old motor out of the refrigerator and discard it.

7. Place the new WR60X10307 GE Refrigerator Evaporator Fan Motor into position.

8. Connect the wires to the new fan motor and tighten them up with a pair of pliers, if necessary.

9. Reattach the fan motor to the bracket using the same screws you removed earlier. Make sure to tighten the screws securely.

10. Using the same amount of insulation from the old fan motor, cover and insulate the new one.

11. Turn on the refrigerator valves and plug the refrigerator back in.

12. Test the operation of the evaporator fan motor and make sure it is operating correctly.

13. Enjoy the satisfaction of having replaced the WR60X10307 GE Refrigerator Evaporator Fan Motor yourself!

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.