WD21X22830 GE Dishwasher Turbidity Sensor
Turbidity sensor works with some GE, and Hotpoint models of dishwashers.
Weight : 0.1102 lbs
Dimension : 3.4251 x 3.0708 x 1.4566
Turbidity sensor works with some GE, and Hotpoint models of dishwashers.
Weight : 0.1102 lbs
Dimension : 3.4251 x 3.0708 x 1.4566
Write Your Own Review
1. Unplug the dishwasher from the power source and turn off the water supply.
2. Open the dishwasher door and pull out the bottom rack.
3. Use a Phillips head screwdriver to remove four screws found on the front underside panel of the dishwasher.
4. Carefully lift the panel to access the dishwasher's interior.
5. Locate the turbidity sensor near the bottom right corner of the dishwasher.
6. Use a pair of needle nose pliers to disconnect the electrical wires connected to the turbidity sensor.
7. Remove the two screws which hold the turbidity sensor in place.
8. Pull the old turbidity sensor out of the dishwasher and discard it.
9. Insert the new turbidity sensor into the same position as the old one. Secure with the two screws.
10. Connect the electrical wires back onto the new turbidity sensor.
11. Reattach the underside panel using the four screws.
12. Push the bottom rack back into the dishwasher.
13. Plug the dishwasher back into the power source and turn on the water supply.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
2. Open the dishwasher door and pull out the bottom rack.
3. Use a Phillips head screwdriver to remove four screws found on the front underside panel of the dishwasher.
4. Carefully lift the panel to access the dishwasher's interior.
5. Locate the turbidity sensor near the bottom right corner of the dishwasher.
6. Use a pair of needle nose pliers to disconnect the electrical wires connected to the turbidity sensor.
7. Remove the two screws which hold the turbidity sensor in place.
8. Pull the old turbidity sensor out of the dishwasher and discard it.
9. Insert the new turbidity sensor into the same position as the old one. Secure with the two screws.
10. Connect the electrical wires back onto the new turbidity sensor.
11. Reattach the underside panel using the four screws.
12. Push the bottom rack back into the dishwasher.
13. Plug the dishwasher back into the power source and turn on the water supply.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
