WP8576635 Whirlpool Bolt
Coin slide bolt works with some Whirlpool, Jenn-Air, Kenmore, KitchenAid, Maytag, Amana, Magic Chef, Admiral, Norge, and Roper models of washer/dryers.
Weight : 0.0576 lbs
Dimension : 7.75 x 0.25 x 0.25
Product Details
Reviews
Replaces Parts
Installation Instructions
Compatible Models
Compatible Brands
Coin slide bolt works with some Whirlpool, Jenn-Air, Kenmore, KitchenAid, Maytag, Amana, Magic Chef, Admiral, Norge, and Roper models of washer/dryers.
Weight : 0.0576 lbs
Dimension : 7.75 x 0.25 x 0.25
Write Your Own Review
The following parts are replaced by this product
- 8318517
- 3400216
- 8576635
- 352479
DIY Instructions for Replacing a Whirlpool Washer/Dryer WP8576635 Coin Slide Bolt
Replacing a coin slide bolt in a Whirlpool washer/dryer with the model number WP8576635 just requires a few simple steps. Follow this DIY guide to learn how to replace it for yourself.
Tools Needed:
- Screwdriver
- New coin slide bolt
Instructions:
1. Start by disconnecting the washer/dryer from the power source and turning off the water supply.
2. Take out the drain hose connected to the back of the unit and the inlet hoses connected to the side.
3. Use a screwdriver to remove the screws that hold the control panel in place.
4. Carefully lift up the control panel, exposing the coin slide bolt beneath.
5. Use a screwdriver to unscrew the old coin slide bolt and then put in the new one.
6. Secure the new coin slide bolt with screws and then replace the control panel.
7. Reattach the inlet hoses and the drain hose and then turn on the water supply.
8. Finally, reconnect the washer/dryer to the power source.
Your Whirlpool washer/dryer WP8576635 should now be ready to use with its new coin slide bolt!
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Replacing a coin slide bolt in a Whirlpool washer/dryer with the model number WP8576635 just requires a few simple steps. Follow this DIY guide to learn how to replace it for yourself.
Tools Needed:
- Screwdriver
- New coin slide bolt
Instructions:
1. Start by disconnecting the washer/dryer from the power source and turning off the water supply.
2. Take out the drain hose connected to the back of the unit and the inlet hoses connected to the side.
3. Use a screwdriver to remove the screws that hold the control panel in place.
4. Carefully lift up the control panel, exposing the coin slide bolt beneath.
5. Use a screwdriver to unscrew the old coin slide bolt and then put in the new one.
6. Secure the new coin slide bolt with screws and then replace the control panel.
7. Reattach the inlet hoses and the drain hose and then turn on the water supply.
8. Finally, reconnect the washer/dryer to the power source.
Your Whirlpool washer/dryer WP8576635 should now be ready to use with its new coin slide bolt!
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
No more associated models for this part.
