WP3392906 Whirlpool Door Handle

Step 1: Gather the necessary tools and materials. To replace the Whirlpool WP3392906 HANDLE, you will need a Phillips screwdriver, flathead screwdriver, needle nose pliers, hand towel, and your new Whirlpool WP3392906 HANDLE.

Step 2: Make sure that the appliance is unplugged and the power supply is turned off. Carefully remove the screws from the handle with a Phillips screwdriver.

Step 3: Pull off the old handle from the door of the appliance. If it does not come away easily, gently pry it loose with the flathead screwdriver or use the needle nose pliers to unhook and separate any cables or wires.

Step 4: Use the hand towel to wipe down and clean the door where the new handle will be installed.

Step 5: Install the new handle. Align the holes of the new handle with the holes on the door, then securely fasten the screws with the Phillips screwdriver.

Step 6: Plug the appliance in and turn the power supply back on to test the new handle. Make sure that the handle is securely attached and that it feels sturdy while using.

And that’s it! You have now replaced the Whirlpool WP3392906 HANDLE.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.