W11084156 Whirlpool Dishwasher Filter Pump

How to Replace a Whirlpool W11084156 Filter Pump

Replacing a filter pump in a Whirlpool appliance can be a simple task when done correctly and safely. Follow these step-by-step instructions to replace the Whirlpool W11084156 filter pump.

Safety First: Before beginning, make sure to shut off power to the device. Unplug the appliance from the power source and turn off all water supplies that are connected to the system.

Step 1: Locate the filter pump. The filter pump is typically located in or near the back of the appliance, near the motor.

Step 2: Remove the old filter pump. Gently pry off the two screws that are holding the filter pump in place. Then, pull the filter pump out of its housing.

Step 3: Install the new filter pump. Insert the new filter pump into the same location as the old one, making sure it is secure. Reattach the two screws that were removed in Step 2.

Step 4: Test the new filter pump. Reconnect the power source and turn on the water supplies. Test the filter pump by running it through several cycles.

Step 5: Clean up any mess. It is important to clean up any debris or excess water that may have spilled during the installation process.

You have now successfully replaced the Whirlpool W11084156 filter pump! With these simple steps and proper safety precautions, you should be able to complete this job quickly and easily.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.