2361 U-Line Ice Maker Wire Harness / Spark Module
Part #: ULC 2361
2361 U-Line Ice Maker Wire Harness/Spark Module
Weight : 0.000000 lbs
2361 U-Line Ice Maker Wire Harness/Spark Module
Weight : 0.000000 lbs
Write Your Own Review
Replacing the SPARK MODULE 2+0
1. Disconnect the power to the SPARK MODULE 2+0. Make sure to turn off the power switch located at the back of the unit and unplug it from the power source.
2. Carefully unscrew the mounting screws located on the bottom of the unit and remove the module.
3. Place the new SPARK MODULE 2+0 in the same position and use the mounting screws to secure it in place.
4. Connect your wiring to the correct terminals of the SPARK MODULE 2+0.
5. Plug the SPARK MODULE 2+0 back into the power source and turn it on.
6. Test the operation of the SPARK MODULE 2+0 to ensure it is working correctly.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
1. Disconnect the power to the SPARK MODULE 2+0. Make sure to turn off the power switch located at the back of the unit and unplug it from the power source.
2. Carefully unscrew the mounting screws located on the bottom of the unit and remove the module.
3. Place the new SPARK MODULE 2+0 in the same position and use the mounting screws to secure it in place.
4. Connect your wiring to the correct terminals of the SPARK MODULE 2+0.
5. Plug the SPARK MODULE 2+0 back into the power source and turn it on.
6. Test the operation of the SPARK MODULE 2+0 to ensure it is working correctly.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
No more associated models for this part.
