Klein Tools Tools

For use with Klein hole saws 1-3/8-Inch to 6-3/8-Inch (35 mm to 162 mm)Pins lock the saw to prevent over-tighteningHardened mandrel for long thread lifeFast and easy to engage ... and disengage hole sawSteel construction for added durability118-degree split point pilot bits Read More Read Less

Optimized teeth pattern for fast, consistent cutting of steel including stainlessKit contains the most popular sizes for basic electrical work: 7/8-Inch, 1-1/8-Inch, 1-3/8-Inc ...h, 1-3/4-Inch, 2-Inch and 2-1/2-Inch (2.2, 2.9, 3.5, 4.4, 5.1 and 6.4 cm) sawsCuts precise holes in both mild and stainless steel, drywall, ceiling tile, laminates, wood, and plasticBore through 2x4s in a single passMultiple leverage points for easy slug removalIncludes two arbors and a rugged carrying caseNOTE: Set pilot drill point 1/8-Inch beyond tooth points Read More Read Less

GFCI Tester detects the most common wiring problems in standard and GFCI receptaclesWorks on GFCI outlets and confirms operation of the ground fault protective deviceBuilt to ...withstand a 6.6-foot (2m) dropOperating temp: 32-Degree to 140-Degree Fahrenheit (0-Degree to 40-Degree Celsius)Nominal Voltage: 110/125V AC at 50/60Hz in 3-wire outlet Read More Read Less

Tool bag is made of flame resistant No. 4 canvasElectrician Tool Pouch has tunnel loop to fit belts up to 3-Inch (7.6 cm) wideMeets the performance requirement of NFPA -701Sti ...tched and riveted with a double-bottom for added durabilityBolt bag with bull-pin loop on each sideDouble-bottom for added protection on the jobAssembled in USA of U.S. and imported components Read More Read Less

This is a genuine Klein Tool

Nut Drivers with through-handle, full-hollow shaft for torquing hex nuts onto threaded rod of any lengthDriver handles with color coding for easy identification of different s ...izesWrench-assist for additional torqueRare-Earth magnetic tip holds nut in place while fasteningHeavy duty handles and shafts exceed the torque performance of regular nut driversIncludes 1/4-Inch, 5/16-Inch, 3/8-Inch and 7/16-Inch hex sizes Read More Read Less

Interchangeable insulated flip-blades with a slim-tip to fit tight terminal blocksIncludes 3 double-ended blades: a #2 Phillips / 1/4-Inch Slotted; a #1 Phillips / 3/16-inch S ...lotted; and a #1 Square / #2 SquareDouble-ended blades have a 3.5-Inch shaft length out of handleWhen used with Klein insulated handle, blades have a 1000-Volt insulation ratingHandle with blade meets or exceeds ASTM F1505 standard for insulationA layer of orange impact and flame resistant insulation protects from electric shockFor use with Klein Tools' Insulated Interchangeable Screwdrivers: Catalog Numbers 32286, 32287, 32288, 32293 Read More Read Less

This is a genuine OEM Klein Tool.