202937 Speed Queen Washer Pressure Switch with 10.0 Max Infinite Cam
202937 Speed Queen Washer Pressure Switch (10.0 Max Infinite Cam)
Weight : 0.399400 lbs
Dimension : 5.590500 x 3.503900 x 2.834600
202937 Speed Queen Washer Pressure Switch (10.0 Max Infinite Cam)
Weight : 0.399400 lbs
Dimension : 5.590500 x 3.503900 x 2.834600
Write Your Own Review
DIY Tips for Replacing a 202937 Speed Queen Washer Pressure Switch (10.0 Max Infinite Cam)
1. Start by disconnecting the power source from the washer and shutting off the water supply to the machine.
2. Locate the pressure switch on the back of the washer. It will be mounted in place with two small Philips head screws.
3. Remove the screws and carefully remove the pressure switch from the back of the washer.
4. Note the position of the wires that are connected to the pressure switch. This will help you reconnect it correctly later.
5. Install the new pressure switch by connecting the wires in the same places as before, and then tightening down the two screws to secure it in place.
6. Reconnect the power source and water supply to the washer.
7. Test the washer by running it through a cycle to make sure that the pressure switch is functioning correctly.
Following these simple steps will ensure a successful replacement of your 202937 Speed Queen washer pressure switch. Make sure to use caution when dealing with electricity, since even a slight misstep could result in serious injury.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
1. Start by disconnecting the power source from the washer and shutting off the water supply to the machine.
2. Locate the pressure switch on the back of the washer. It will be mounted in place with two small Philips head screws.
3. Remove the screws and carefully remove the pressure switch from the back of the washer.
4. Note the position of the wires that are connected to the pressure switch. This will help you reconnect it correctly later.
5. Install the new pressure switch by connecting the wires in the same places as before, and then tightening down the two screws to secure it in place.
6. Reconnect the power source and water supply to the washer.
7. Test the washer by running it through a cycle to make sure that the pressure switch is functioning correctly.
Following these simple steps will ensure a successful replacement of your 202937 Speed Queen washer pressure switch. Make sure to use caution when dealing with electricity, since even a slight misstep could result in serious injury.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
