DG94-01856A Samsung Assembly Knob

Replacing the Samsung DG94-01856A Assembly Knob: A DIY Guide

If your Samsung DG94-01856A assembly knob is cracked, old, or no longer functions correctly, replacing it is a relatively simple task. The following step-by-step DIY instructions will help ensure the replacement process is done correctly and safely.

Materials Needed

• New Samsung DG94-01856A assembly knob
• Flat-head screwdriver
• Phillips-head screwdriver

Instructions
1. Unplug the appliance from the power source. This can be done by either unplugging the cord from the wall outlet or flipping the circuit breaker switch for the appliance.

2. Use the flat-head screwdriver to remove the screws on the rear of the control panel.

3. Carefully lift up the front of the control panel to gain access to the old assembly knob.

4. Remove the old assembly knob by pulling it away from the shaft.

5. Insert the new knob onto the shaft and align it so that the grooves line up with the notches on the knob.

6. Secure the new assembly knob with the screws on the back of the control panel and ensure they are tight.

7. Replace any other components and screws that had been removed.

8. Re-plug the appliance into the power source and test the new assembly knob to make sure everything is working properly.

Congratulations! You have successfully replaced the Samsung DG94-01856A assembly knob.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.