DE81-07046A Samsung Range Hot Surface Igniter Assembly
Hot surface igniter works with some Dacor models of stoves / ovens / ranges.
Weight : 0.171400 lbs
Dimension : 5.196800 x 2.283400 x 2.007800
Hot surface igniter works with some Dacor models of stoves / ovens / ranges.
Weight : 0.171400 lbs
Dimension : 5.196800 x 2.283400 x 2.007800
Write Your Own Review
DIY Guide to Replacing Samsung Range Model DE81-07046A’s Hot Surface Igniter
Need to replace your Samsung Range Model DE81-07046A’s hot surface igniter? This DIY guide will provide you with the steps necessary to accomplish this task quickly and efficiently.
What You’ll Need:
• A new hot surface igniter for Samsung Range Model DE81-07046A
• Phillips head screwdriver
• Flat head screwdriver
• Needle nose pliers
• Multimeter
Step 1: Unplug the range from the power source.
Step 2: Remove the rear panel of your range by unscrewing the screws that are holding it in place. Make sure to keep track of all the screws as you will need them to replace the rear panel once you are done.
Step 3: Locate the old hot surface igniter and disconnect it from the wiring harness. Use the needle nose pliers to gently remove the wires.
Step 4: Grab the new hot surface igniter, connect the wiring harness, and secure it into place using the supplied hardware.
Step 5: Now, check the connections of the new hot surface igniter with a multimeter. If all connections are good, reattach the rear panel of the range and plug it back into the power source.
Step 6: Turn on the range and check if the new hot surface igniter is working properly.
Congratulations! You have now replaced the Hot Surface Igniter in your Samsung Range Model DE81-07046A.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Need to replace your Samsung Range Model DE81-07046A’s hot surface igniter? This DIY guide will provide you with the steps necessary to accomplish this task quickly and efficiently.
What You’ll Need:
• A new hot surface igniter for Samsung Range Model DE81-07046A
• Phillips head screwdriver
• Flat head screwdriver
• Needle nose pliers
• Multimeter
Step 1: Unplug the range from the power source.
Step 2: Remove the rear panel of your range by unscrewing the screws that are holding it in place. Make sure to keep track of all the screws as you will need them to replace the rear panel once you are done.
Step 3: Locate the old hot surface igniter and disconnect it from the wiring harness. Use the needle nose pliers to gently remove the wires.
Step 4: Grab the new hot surface igniter, connect the wiring harness, and secure it into place using the supplied hardware.
Step 5: Now, check the connections of the new hot surface igniter with a multimeter. If all connections are good, reattach the rear panel of the range and plug it back into the power source.
Step 6: Turn on the range and check if the new hot surface igniter is working properly.
Congratulations! You have now replaced the Hot Surface Igniter in your Samsung Range Model DE81-07046A.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
