DC97-14370H Samsung Assembly Flange Shaft
DC97-14370H Samsung Assembly Flange Shaft
Weight : 0.000000 lbs
DC97-14370H Samsung Assembly Flange Shaft
Weight : 0.000000 lbs
Write Your Own Review
DIY Instructions on Replacing the Samsung DC97-14370H ASSY FLANGE SHAFT;WD0804W8N1
Replacing the Samsung DC97-14370H Assy Flange Shaft is not a difficult process. With the right tools and a bit of patience, anyone can do it in no time. Follow the instructions below to replace this part easily.
Materials Needed:
-Flathead screwdriver
-Phillips head screwdriver
-Ratchet and socket set
-Replacement Samsung DC97-14370H Assy Flange Shaft
Instructions:
1. Disconnect the power to the washing machine before starting.
2. Use a flathead screwdriver to remove the screws holding down the appliance's top corner trim. Remove the trim and set aside.
3. Locate the two screws on the back of the appliance that hold the rear panel in place. Unscrew these with a Phillips head screwdriver. Lift the panel off the appliance and set aside.
4. Using a ratchet and socket set, remove the four bolts from the flange shaft that's located at the bottom left corner of the machine housing.
5. Pull the old flange shaft out of the machine and discard it.
6. Take the new replacement Samsung DC97-14370H Assy Flange Shaft and drop it into place. Make sure it is firmly seated and aligned correctly.
7. Replace the four bolts and tighten them down with the ratchet and socket set.
8. Replace the rear panel and secure it with the two screws.
9. Replace the top corner trim and secure it with the flathead screws.
10. Reconnect the power to the washing machine and you're done!
You have completed replacing the Samsung DC97-14370H Assy Flange Shaft.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Replacing the Samsung DC97-14370H Assy Flange Shaft is not a difficult process. With the right tools and a bit of patience, anyone can do it in no time. Follow the instructions below to replace this part easily.
Materials Needed:
-Flathead screwdriver
-Phillips head screwdriver
-Ratchet and socket set
-Replacement Samsung DC97-14370H Assy Flange Shaft
Instructions:
1. Disconnect the power to the washing machine before starting.
2. Use a flathead screwdriver to remove the screws holding down the appliance's top corner trim. Remove the trim and set aside.
3. Locate the two screws on the back of the appliance that hold the rear panel in place. Unscrew these with a Phillips head screwdriver. Lift the panel off the appliance and set aside.
4. Using a ratchet and socket set, remove the four bolts from the flange shaft that's located at the bottom left corner of the machine housing.
5. Pull the old flange shaft out of the machine and discard it.
6. Take the new replacement Samsung DC97-14370H Assy Flange Shaft and drop it into place. Make sure it is firmly seated and aligned correctly.
7. Replace the four bolts and tighten them down with the ratchet and socket set.
8. Replace the rear panel and secure it with the two screws.
9. Replace the top corner trim and secure it with the flathead screws.
10. Reconnect the power to the washing machine and you're done!
You have completed replacing the Samsung DC97-14370H Assy Flange Shaft.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
