DC61-01257L Samsung Washer Hanger Spring
Part #: SMG DC61-01257L
Hanger Spring works with some models of Samsung Washers
Weight : 0.0569 lbs
Dimension : 4.7637 x 1.4566 x 1.1417
Hanger Spring works with some models of Samsung Washers
Weight : 0.0569 lbs
Dimension : 4.7637 x 1.4566 x 1.1417
Write Your Own Review
Replacing the DC61-01257L Samsung Washer Hanger Spring
Tools Needed:
Phillips Head Screwdriver
Instructions:
1. Unplug the washer from its power source before starting the repair.
2. Remove the back cover of the washer. Use a Phillips head screwdriver to remove the screws located at the bottom of the panel.
3. Once the back panel is removed, locate the spring on the back side of the washer drum.
4. Pull the hanger end of the spring off from it’s pin.
5. Remove the old spring and replace with a new one.
6. Replace the back panel and secure with screws.
7. Plug in the washer and test the spring to ensure it works properly.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Tools Needed:
Phillips Head Screwdriver
Instructions:
1. Unplug the washer from its power source before starting the repair.
2. Remove the back cover of the washer. Use a Phillips head screwdriver to remove the screws located at the bottom of the panel.
3. Once the back panel is removed, locate the spring on the back side of the washer drum.
4. Pull the hanger end of the spring off from it’s pin.
5. Remove the old spring and replace with a new one.
6. Replace the back panel and secure with screws.
7. Plug in the washer and test the spring to ensure it works properly.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.