HK06MB021 Carrier Dual Pressure Switch

1. Before beginning any work on the HK06MB021 Pressure Switch, make sure you have unplugged any electrical power sources and turned off the water supply to the pressure switch.

2. Carefully remove the existing pressure switch from its mounting plate.

3. Take a few moments to inspect the old pressure switch for any signs of wear or damage. If the pressure switch is beyond repair, now is the time to replace it with a new one.

4. Install the new pressure switch onto the mounting plate and make sure all electrical connections are properly secured.

5. Test the pressure switch to ensure proper functioning by plugging in the electrical power source and turning on the water supply.

6. Carefully adjust the settings on the pressure switch until the desired pressure is reached.

7. Once the desired pressure setting has been achieved, carefully turn off the water supply and then unplug the electrical power source once again.

8. Finally, secure the pressure switch onto the mounting plate and verify that all electrical connections are properly secured.

By following these simple steps, you should have successfully replaced the HK06MB021 Pressure Switch!

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.