6501EA1001R LG Washer Water Level Pressure Sensor Switch

Replacing the 6501EA1001R LG Washer Water Level Pressure Sensor Switch

Step 1: Unplug the washer – Before starting any repair, make sure to unplug your washer from the power supply.

Step 2: Remove the front panel – Slide the front panel back and lift it off the machine.

Step 3: Locate the pressure sensor switch – The pressure sensor switch will be situated near the water inlet valve at the rear of the washer.

Step 4: Disconnect the hoses – Disconnect the two hoses connected to the pressure sensor switch and detach the hose clamp.

Step 5: Remove the old pressure sensor switch – Unscrew the retaining bolts or screws that hold the pressure sensor switch in place and carefully remove it.

Step 6: Install the new pressure sensor switch – Place the new pressure sensor switch in the correct location and secure it in place with the retaining bolts.

Step 7: Connect the hoses – Attach the two hoses to the pressure sensor switch and tighten the hose clamp.

Step 8: Reattach the front panel – Slide the front panel back in place and secure it.

Step 9: Plug in the washer – Plug the washer back in and test the new pressure sensor switch.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.