4861ER2001J LG Washer Door Boot Spring Clamp Assembly
Door boot spring clamp assembly for some models of LG washing machines.
Weight : 1.2114 lbs
Dimension : 12.8 x 15.3 x 1.2
Product Details
Reviews
Replaces Parts
Installation Instructions
Compatible Models
Compatible Brands
Door boot spring clamp assembly for some models of LG washing machines.
Weight : 1.2114 lbs
Dimension : 12.8 x 15.3 x 1.2
Write Your Own Review
The following parts are replaced by this product
- 4861EN3004J
Replacing the 4861ER2001J LG Washer Door Boot Spring Clamp Assembly
Step 1: Unplug your washer from the wall outlet.
Step 2: Remove the screws holding the top panel. Lift up the top panel and set it aside.
Step 3: Remove the four screws that hold the front panel in place. Pull the front panel off and set it aside.
Step 4: Disconnect the water supply hose from the back side of the washer.
Step 5: Locate the door boot spring clamp assembly and remove the screws holding it in place.
Step 6: Install the new door boot spring clamp assembly and tighten the screws to secure it.
Step 7: Re-connect the water supply hose and replace the front panel.
Step 8: Replace the four screws that hold the front panel in place and then replace the top panel.
Step 9: Plug your washer back in and test it to ensure it is functioning properly.
Congratulations, you have replaced your 4861ER2001J LG Washer Door Boot Spring Clamp Assembly!
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Step 1: Unplug your washer from the wall outlet.
Step 2: Remove the screws holding the top panel. Lift up the top panel and set it aside.
Step 3: Remove the four screws that hold the front panel in place. Pull the front panel off and set it aside.
Step 4: Disconnect the water supply hose from the back side of the washer.
Step 5: Locate the door boot spring clamp assembly and remove the screws holding it in place.
Step 6: Install the new door boot spring clamp assembly and tighten the screws to secure it.
Step 7: Re-connect the water supply hose and replace the front panel.
Step 8: Replace the four screws that hold the front panel in place and then replace the top panel.
Step 9: Plug your washer back in and test it to ensure it is functioning properly.
Congratulations, you have replaced your 4861ER2001J LG Washer Door Boot Spring Clamp Assembly!
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
