4280EN4001F LG Washer Rear Tub Ball Bearing
Washer rear tub ball bearing for some models of LG washing machines.
Weight : 0.0312 lbs
Dimension : 2.75 x 2.75 x 0.8
Washer rear tub ball bearing for some models of LG washing machines.
Weight : 0.0312 lbs
Dimension : 2.75 x 2.75 x 0.8
Write Your Own Review
DIY Guide to Replacing the 4280EN4001F LG Washer Rear Tub Ball Bearing
The 4280EN4001F LG washer rear tub ball bearing supports the back of the washer drum and helps keep it spinning evenly. Over time, this bearing can become worn or damaged, leading to excessive noise and vibration. Fortunately, replacing it is a relatively simple do-it-yourself project that can be completed in just a few steps.
Tools Needed:
-Phillips head screwdriver
-Pliers
-Socket wrench
Instructions:
1. Start by unplugging the power cord from the wall socket and disconnecting any water hoses from the washer.
2. Remove the screws or clips that secure the top panel of the washer in place. Then, gently lift the top panel off and set it aside.
3. Locate the rear tub ball bearing. It should be mounted on the back of the washer drum.
4. Use a socket wrench to loosen the bolts around the bearing and remove them.
5. Carefully remove the bearing and replace it with the new one. Make sure the new bearing is properly seated and secure the bolts tightly.
6. Replace the top panel, then reconnect the power cord and water hoses.
7. Turn on the washer to ensure it’s working properly. If it runs smoothly, you’re done!
With these easy steps, you can quickly and easily replace the 4280EN4001F LG washer rear tub ball bearing. If you’re having trouble or need help, contact an appliance repair technician for assistance.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
The 4280EN4001F LG washer rear tub ball bearing supports the back of the washer drum and helps keep it spinning evenly. Over time, this bearing can become worn or damaged, leading to excessive noise and vibration. Fortunately, replacing it is a relatively simple do-it-yourself project that can be completed in just a few steps.
Tools Needed:
-Phillips head screwdriver
-Pliers
-Socket wrench
Instructions:
1. Start by unplugging the power cord from the wall socket and disconnecting any water hoses from the washer.
2. Remove the screws or clips that secure the top panel of the washer in place. Then, gently lift the top panel off and set it aside.
3. Locate the rear tub ball bearing. It should be mounted on the back of the washer drum.
4. Use a socket wrench to loosen the bolts around the bearing and remove them.
5. Carefully remove the bearing and replace it with the new one. Make sure the new bearing is properly seated and secure the bolts tightly.
6. Replace the top panel, then reconnect the power cord and water hoses.
7. Turn on the washer to ensure it’s working properly. If it runs smoothly, you’re done!
With these easy steps, you can quickly and easily replace the 4280EN4001F LG washer rear tub ball bearing. If you’re having trouble or need help, contact an appliance repair technician for assistance.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
