WH2X1198 GE Dryer Tub Bearing

100% Guaranteed genuine parts logo
GE General Electric Hotpoint RCA Sears Kenmore Clothes Washer Washing Machine TUB BEARING WH2X1198

We are a Factory Authorized Parts Distributor for General Electric Hotpoint. Trust us for all of your General Electric Hotpoint appliance parts and accessories needs.

Weight : 0.109000 lbs
Dimension : 2.913300 x 2.874000 x 1.811000
Special Price $19.26 Regular Price $21.40 10% off
In stock
GE General Electric Hotpoint RCA Sears Kenmore Clothes Washer Washing Machine TUB BEARING WH2X1198

We are a Factory Authorized Parts Distributor for General Electric Hotpoint. Trust us for all of your General Electric Hotpoint appliance parts and accessories needs.

Weight : 0.109000 lbs
Dimension : 2.913300 x 2.874000 x 1.811000
Write Your Own Review
You're reviewing:WH2X1198 GE Dryer Tub Bearing
Your Rating

Image size should not exceed 5 MB. File format must be JPG or PNG.

The following parts are replaced by this product

  1. WH02X1198
1. Start by unplugging your washing machine and turning off the water supply.
2. Place a bucket under the drain hose and then disconnect it from the standpipe.
3. Use a screwdriver to remove the front panel of the washer and disconnect the wire harness from the motor control board.
4. Remove the screws from the back panel and remove the panel to access the tub bearing.
5. Using an adjustable wrench or pliers, remove the retaining ring and remove the old bearing.
6. Take the new bearing and apply a thin layer of non-detergent soap to the shaft, then slide the bearing over the shaft.
7. Reinstall the retaining ring and securely tighten it with the wrench or pliers.
8. Reattach the back panel to the washer, reconnect the wire harness, and then replace the front panel.
9. Put the drain hose back in place and reconnect it to the standpipe.
10. Turn the water supply back on and plug in the washer. Finally, test the washer to make sure the new bearing is working properly.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
No more associated models for this part.
Compatible with ge Compatible with hotpoint