WH12X10276 GE Washer Door Magnet
Introducing the GE WH12X10276 MAGNET ASM D04,We're your #1 source for genuine OEM appliance parts. Contact us for further questions as well as any other appliance parts needs!
Weight : 0.1295 lbs
Dimension : 6 x 6 x 0.5
Product Details
Reviews
Replaces Parts
Installation Instructions
Compatible Models
Compatible Brands
Introducing the GE WH12X10276 MAGNET ASM D04,We're your #1 source for genuine OEM appliance parts. Contact us for further questions as well as any other appliance parts needs!
Weight : 0.1295 lbs
Dimension : 6 x 6 x 0.5
Write Your Own Review
The following parts are replaced by this product
- WH12X10092
DIY Step-by-Step Guide to Replacing the GE WH12X10276 Magnet Assembly D04
1. Turn off your washer and begin by unplugging it from the wall outlet.
2. Lift the washer lid and locate the magnet assembly D04. It should be located on the bottom of the drum.
3. Disconnect the wiring harness from the magnet assembly.
4. Remove the two screws that hold the magnet assembly in place.
5. Carefully lift the magnet assembly out of the washer, being careful to not damage any wires or parts near the assembly.
6. Place the new magnet assembly into the washer, being sure to align the screws with the holes in the washer.
7. Secure the magnet assembly in place via the two screws you removed earlier.
8. Reconnect the wiring harness to the new magnet assembly.
9. Close the lid of the washer and plug the washer back into the wall outlet.
10. Finally, turn on the washer to ensure that the magnet assembly is working properly.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
1. Turn off your washer and begin by unplugging it from the wall outlet.
2. Lift the washer lid and locate the magnet assembly D04. It should be located on the bottom of the drum.
3. Disconnect the wiring harness from the magnet assembly.
4. Remove the two screws that hold the magnet assembly in place.
5. Carefully lift the magnet assembly out of the washer, being careful to not damage any wires or parts near the assembly.
6. Place the new magnet assembly into the washer, being sure to align the screws with the holes in the washer.
7. Secure the magnet assembly in place via the two screws you removed earlier.
8. Reconnect the wiring harness to the new magnet assembly.
9. Close the lid of the washer and plug the washer back into the wall outlet.
10. Finally, turn on the washer to ensure that the magnet assembly is working properly.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
