WB01X10180 GE Oven Flat Bolt
Part #: GEN WB01X10180
WB01X10180 GE Oven Flat Bolt
Weight : 0.259000 lbs
Dimension : 8.000000 x 7.500000 x 0.600000
WB01X10180 GE Oven Flat Bolt
Weight : 0.259000 lbs
Dimension : 8.000000 x 7.500000 x 0.600000
Write Your Own Review
DIY Instructions on Replacing the GE WB01X10180 BOLT-FLAT
Replacing the GE WB01X10180 BOLT-FLAT doesn’t have to be a difficult task. With the right tools and a little bit of DIY spirit, you can have your appliance back in working order in no time. Follow the steps below to tackle this repair job yourself.
1. Unplug your appliance and turn off the power at the circuit breaker.
2. Remove the screws or bolts that hold the access panel in place. With the access panel off, you will have access to the old BOLT-FLAT.
3. Take out the old BOLT-FLAT by unbolting it and gently wiggling it free. Be careful not to damage surrounding components as you do this.
4. Replace the old BOLT-FLAT with the new one. Secure the new BOLT-FLAT with the same screws or bolts that were used to secure the old one.
5. Put the access panel back into place and secure it with the screws or bolts you removed earlier.
6. Turn the power back on at the circuit breaker and plug in your appliance.
7. Test the appliance to make sure the new BOLT-FLAT has been installed properly.
Follow these steps and you’ll be able to complete the repair of the GE WB01X10180 BOLT-FLAT quickly and easily!
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Replacing the GE WB01X10180 BOLT-FLAT doesn’t have to be a difficult task. With the right tools and a little bit of DIY spirit, you can have your appliance back in working order in no time. Follow the steps below to tackle this repair job yourself.
1. Unplug your appliance and turn off the power at the circuit breaker.
2. Remove the screws or bolts that hold the access panel in place. With the access panel off, you will have access to the old BOLT-FLAT.
3. Take out the old BOLT-FLAT by unbolting it and gently wiggling it free. Be careful not to damage surrounding components as you do this.
4. Replace the old BOLT-FLAT with the new one. Secure the new BOLT-FLAT with the same screws or bolts that were used to secure the old one.
5. Put the access panel back into place and secure it with the screws or bolts you removed earlier.
6. Turn the power back on at the circuit breaker and plug in your appliance.
7. Test the appliance to make sure the new BOLT-FLAT has been installed properly.
Follow these steps and you’ll be able to complete the repair of the GE WB01X10180 BOLT-FLAT quickly and easily!
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.