534699 Fisher & Paykel Cooking Conversion Kit NG to LP for CG365
534699 Fisher & Paykel Cooking Kit Conversion Ng To Lp Gons Cg365
534699 Fisher & Paykel Cooking Kit Conversion Ng To Lp Gons Cg365
Write Your Own Review
DIY Instructions on Replacing Fisher & Paykel 534699 KIT CONV NG to LP GONS CG365
1. Start by turning off the gas supply to the appliance, as LP conversion instructions require you to work on the original gas configuration before making modifications. Unplug the unit from its power source, and use a wrench to disconnect the supply line from the appliance.
2. Remove the bottom grille and locate the gas valve. This is found at the back of the unit, facing the wall. The gas valve will be located on the left side.
3. Lift the gas valve out of the unit, being careful not to disturb any wiring or connectors.
4. Take the Fisher & Paykel 534699 KIT CONV NG and connect it to the connection point where you removed the gas valve. Secure it with the enclosed nuts, bolts, and washers. Make sure the connections are tight but do not over-tighten them.
5. Reconnect the power supply to the appliance and turn the gas supply back on.
6. Test the pressure regulator for proper functioning by igniting the pilot light. You should see a steady blue flame when open. If the flame flickers, adjust the regulator until it is stable.
7. After testing the regulator, turn it back to its original setting. Test the pressure once more to make sure the new regulator is functioning properly.
8. Replace the bottom grille and ensure all connections are secure throughout the entire process.
By following these steps, you can successfully replace your Fisher & Paykel 534699 KIT CONV NG to LP GONS CG365. Be sure to always follow all safety precautions when performing any type of DIY project.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
1. Start by turning off the gas supply to the appliance, as LP conversion instructions require you to work on the original gas configuration before making modifications. Unplug the unit from its power source, and use a wrench to disconnect the supply line from the appliance.
2. Remove the bottom grille and locate the gas valve. This is found at the back of the unit, facing the wall. The gas valve will be located on the left side.
3. Lift the gas valve out of the unit, being careful not to disturb any wiring or connectors.
4. Take the Fisher & Paykel 534699 KIT CONV NG and connect it to the connection point where you removed the gas valve. Secure it with the enclosed nuts, bolts, and washers. Make sure the connections are tight but do not over-tighten them.
5. Reconnect the power supply to the appliance and turn the gas supply back on.
6. Test the pressure regulator for proper functioning by igniting the pilot light. You should see a steady blue flame when open. If the flame flickers, adjust the regulator until it is stable.
7. After testing the regulator, turn it back to its original setting. Test the pressure once more to make sure the new regulator is functioning properly.
8. Replace the bottom grille and ensure all connections are secure throughout the entire process.
By following these steps, you can successfully replace your Fisher & Paykel 534699 KIT CONV NG to LP GONS CG365. Be sure to always follow all safety precautions when performing any type of DIY project.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
No more associated models for this part.
