212306 Fisher & Paykel BBQ Ramp Module

DIY Guide to Replacing the Fisher & Paykel 212306 RAM MODULE
To complete this task, you will need a few tools: a Phillips head screwdriver, a flathead screwdriver, and a replacement Fisher & Paykel 212306 RAM Module. With these tools, you can easily replace the RAM module in no time.

Step 1: Unplug the power cord from your appliance.

Step 2: Pull the top of the appliance off. This can be done by pressing two side tabs.

Step 3: Take off the access panel on the back of the appliance. This is held on by several screws, which can be removed with a Phillips head screwdriver.

Step 4: Locate the Fisher & Paykel 212306 RAM Module. It should be located at the lower right corner of the appliance.

Step 5: Use a flathead screwdriver to unscrew the RAM module, then remove it by pulling it straight up and out.

Step 6: Insert the new RAM module and screw it into place with a flathead screwdriver.

Step 7: Replace the access panel and the top of the appliance.

Step 8: Plug the power cord back in and turn the appliance on to see if the RAM module has been successfully replaced.

And that's it! You have now successfully replaced your Fisher & Paykel 212306 RAM Module. If you need help following these instructions, please consult your manual or contact an authorized Fisher & Paykel service center for assistance.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.