1293 Dutro Company Hand Truck/Ratchet Strap(Lp)
Part #: DUT 1293
This is a genuine OEM part made by DUTRO COMPANY
Product Details
Reviews
Replaces Parts
Installation Instructions
Compatible Models
Compatible Brands
This is a genuine OEM part made by DUTRO COMPANY
Write Your Own Review
The following parts are replaced by this product
- 1293
Replacing the 3045EL1002P LG Dryer Drum Tub Assembly
Instructions
1. Unplug the dryer from the power outlet and remove the lint screen.
2. Take off the lint filter housing by unscrewing the two screws on the bottom of the dryer.
3. Slide the top panel of the dryer up and off.
4. Unscrew the drum’s four screws on the outer ring.
5. Disconnect the wiring harness connecting the drum to the motor.
6. Pull the drum out of the dryer housing.
7. Remove the old drum tub assembly by using a screwdriver to remove the screws on the side of the assembly.
8. Slide the new 3045EL1002P LG Dryer Drum Tub Assembly into the dryer housing.
9. Reconnect the wiring harness back to the motor.
10. Screw the outer ring of the drum back into the housing.
11. Slide the top panel of the dryer back onto the housing.
12. Replace the lint filter housing and securely screw it in place.
13. Replace the lint screen and plug the dryer back into the power outlet.
14. Test the dryer by running it on a high-heat cycle.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Instructions
1. Unplug the dryer from the power outlet and remove the lint screen.
2. Take off the lint filter housing by unscrewing the two screws on the bottom of the dryer.
3. Slide the top panel of the dryer up and off.
4. Unscrew the drum’s four screws on the outer ring.
5. Disconnect the wiring harness connecting the drum to the motor.
6. Pull the drum out of the dryer housing.
7. Remove the old drum tub assembly by using a screwdriver to remove the screws on the side of the assembly.
8. Slide the new 3045EL1002P LG Dryer Drum Tub Assembly into the dryer housing.
9. Reconnect the wiring harness back to the motor.
10. Screw the outer ring of the drum back into the housing.
11. Slide the top panel of the dryer back onto the housing.
12. Replace the lint filter housing and securely screw it in place.
13. Replace the lint screen and plug the dryer back into the power outlet.
14. Test the dryer by running it on a high-heat cycle.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
No more associated models for this part.
