A5815-090-H-BS Danby Heat Exhaust Hose Connector

1. Before starting any work on your Danby A5815-090-H-BS Heat Exhaust Hose Connector, turn off the power to the appliance and unplug it from the wall outlet.

2. Locate the old heat exhaust hose connector which is usually located on the back side of the appliance.

3. Loosen the screws or nuts holding the old connector in place with a screwdriver or wrench, depending on the appliance's design.

4. Carefully remove the old heat exhaust connector.

5. Install the new connector in place, ensuring that it fits snugly into the hole in the appliance.

6. Secure the new connector with screws or nuts, again depending on the appliance's design.

7. Plug the appliance back into the wall outlet, and turn it back on.

8. Test the new connector by running the appliance for a few minutes to make sure everything is working properly.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.