20000246 Bosch Refrigerator Traverse
20000246 Bosch Refrigerator Traverse
Weight : 2.586800 lbs
Dimension : 45.433000 x 2.913300 x 2.716500
20000246 Bosch Refrigerator Traverse
Weight : 2.586800 lbs
Dimension : 45.433000 x 2.913300 x 2.716500
Write Your Own Review
Step-by-Step DIY Guide to Replace a Bosch 20000246 Traverse
1. Safety: Before performing any maintenance on your Bosch 20000246 Traverse, make sure to turn off the power to the saw completely and disconnect it from any power source. Wear protective eyewear and gloves when replacing this part.
2. Remove the old traverse: Using a screwdriver, remove the two screws holding the old traverse in place. Carefully slide out the old traverse and set aside.
3. Install the new traverse: Take the new Bosch 20000246 traverse and position it in the same location as the old traverse. Employ a small clamp to hold the traverse in place. Secure the traverse with the two screws that were previously removed.
4. Test the installation: Turn the power on and slowly move the traverse back and forth to ensure it is working properly and that there are no obstructions. If the traverse does not move smoothly, turn off the power again and adjust the position of the traverse until it moves smoothly.
5. Final steps: Once the installation is complete, clean up any debris that may have been created during the installation process. Make sure to dispose of the old traverse properly.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
1. Safety: Before performing any maintenance on your Bosch 20000246 Traverse, make sure to turn off the power to the saw completely and disconnect it from any power source. Wear protective eyewear and gloves when replacing this part.
2. Remove the old traverse: Using a screwdriver, remove the two screws holding the old traverse in place. Carefully slide out the old traverse and set aside.
3. Install the new traverse: Take the new Bosch 20000246 traverse and position it in the same location as the old traverse. Employ a small clamp to hold the traverse in place. Secure the traverse with the two screws that were previously removed.
4. Test the installation: Turn the power on and slowly move the traverse back and forth to ensure it is working properly and that there are no obstructions. If the traverse does not move smoothly, turn off the power again and adjust the position of the traverse until it moves smoothly.
5. Final steps: Once the installation is complete, clean up any debris that may have been created during the installation process. Make sure to dispose of the old traverse properly.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
No more associated models for this part.
