W10837249 Whirlpool Lower Wash Arm

Step 1: Unplug the Dishwasher - Before attempting any repairs, it is important to make sure that your power source is shut off by unplugging the dishwasher.

Step 2: Remove the Dish Rack - To get started, you'll need to remove the dish rack and cutlery basket from the dishwasher to gain access to the arm-spray.

Step 3: Locate and Remove the Screws - You'll need to locate the screws securing the arm-spray in place. These screws can be located underneath the top of the unit as well as near the bottom.

Step 4: Disconnect the Arm Spray Hose - Once you have removed the screws, you'll need to disconnect the arm-spray's hose. This can be done by grasping the plastic tab at the base of the hose and sliding it out of place.

Step 5: Install the New Arm Spray - Once the hose has been disconnected, you can now install the new arm-spray. Make sure to follow the instructions from the manufacturer and secure the arm-spray with its corresponding screws.

Step 6: Reconnect the Arm Spray Hose - After the arm-spray has been secured in place, reconnect the hose back on. Make sure to double-check the connection by tugging gently on the hose a few times.

Step 7: Test the New Arm Spray - To make sure everything is installed properly, run a test cycle and observe the arm-spray to ensure water is spraying out of its nozzles evenly.

Step 8: Reinstall the Dish Rack - Once you've verified that the arm-spray is working properly, reinstall the dish rack and cutlery basket to the dishwasher.

Step 9: Plug the Dishwasher Back In - Now that all the repairs are complete, make sure the power source is off and plug the dishwasher back in.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.