CLS30820101 LG Thermistor Assembly

How to Replace the LG CLS30820101 Thermistor Assembly

1. Unplug your refrigerator from the wall outlet and shut off the water supply line leading to the refrigerator if applicable.

2. Locate the thermistor assembly in the refrigerator. This component is typically located on the air duct, behind the rear panel in the freezer compartment.

3. Disconnect any wires connected to the thermistor assembly.

4. Remove the screws holding the thermistor assembly in place. Carefully pull out the old thermistor assembly and discard it.

5. Install the new thermistor assembly in its place. Be sure to use the appropriate size and grade of screws.

6. Reconnect the wires to the new thermistor assembly.

7. Reassemble the refrigerator in reverse order of how you disassembled it. Be sure to secure all screws and clips firmly in place.

8. Plug your refrigerator back into the wall outlet and turn on the water supply line, if applicable.

9. Test the new thermistor assembly by running the refrigerator for several hours and monitoring it for proper temperature control.

By following these steps, you should have successfully replaced your LG CLS30820101 Thermistor Assembly.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.