5859EA1004G LG Water Drain Pump Assembly

Here are step-by-step instructions on how to replace the 5859EA1004G LG Washer Water Drain Pump Assembly:

1. Shut off the power. Unplug the washer or shut off the breaker in the main circuit panel that supplies it with electricity.

2. Disconnect the fill and drain hoses connected to the water pump. Remove any hose clamps that may be holding them in place.

3. Take off the bottom access panel. It is held in place with screws, which will need to be removed before you can access the pump.

4. Unscrew the two mounting bolts that secure the pump in place. There will be two on the top of the pump and one on the side.

5. Pull the pump out of the washer. If it does not come out easily, there may be more screws or nuts holding it in place.

6. Disconnect the wire harness from the motor.

7. Install the new drain pump. Secure it in place with the mounting screws.

8. Connect the wire harness to the new motor.

9. Reattach the fill and drain hoses. Make sure they’re fitted securely using hose clamps.

10. Reinstall the access panel.

11. Plug the washer back in or turn the circuit breaker back on.

12. Test the washer by running a cycle. If it operates properly, you’ve successfully replaced the 5859EA1004G LG Washer Water Drain Pump Assembly.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.