WH02X10237 GE Washing Machine Screw 1/4-20 Mch Hxw 5/8 S

DIY Guide to Replacing the GE WH02X10237 SCR 1/4-20 MCH HXW 5/8 S

Replacing the GE WH02X10237 SCR 1/4-20 MCH HXW 5/8 S is a relatively easy repair that anyone can do with some basic tools. This guide will provide you with step-by-step instructions to help you complete the repair successfully.

Tools Needed:
• Phillips Screwdriver
• Flat Head Screwdriver
• Socket Wrench
• 1/4”-20 Screws

Step 1: Unscrew the old fastener using a Phillips screwdriver and remove it completely from the washing machine.

Step 2: Unscrew the existing hanger pin from the side of the washing machine and lift it away from the drum.

Step 3: Using a flathead screwdriver, unscrew and remove the existing bracket from the side of the washing machine.

Step 4: Insert the new 1/4”-20 screws into the side of the washing machine. Make sure the screws are securely tightened in place.

Step 5: Attach the new GE WH02X10237 SCR 1/4-20 MCH HXW 5/8 S to the top of the washing machine. Securely tighten the new fastener in place.

Step 6: Replace the hanger pin and secure it with a socket wrench.

Step 7: Test the washer to make sure the new fastener is working properly.

Congratulations! You have successfully replaced the GE WH02X10237 SCR 1/4-20 MCH HXW 5/8 S.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.