62-23543-01 Comfort-Aire Furnace Flame Sensor

Instructions for Replacing the 62-23543-01 Furnace Flame Sensor

1. Start by shutting off the power to your furnace. You can do this by turning off the circuit breaker in your home.

2. Locate the flame sensor. It should be located next to the heat exchanger of your furnace.

3. Remove the existing flame sensor. Start by disconnecting the wires from the terminal and then unscrewing the sensor from its mounting bracket.

4. Install the replacement sensor. Start by screwing it into the mounting bracket and then reconnect the wires from the terminal.

5. Turn the power back on to your furnace.

6. Test the new flame sensor for proper functioning by turning on the furnace. If all is working properly, then the furnace should light up.

7. If the furnace does not light up or if the flame sensor trips multiple times, then check to make sure the new flame sensor was properly installed. If you are unsure of your work, then contact a professional.

Following these simple instructions should help you easily replace your 62-23543-01 furnace flame sensor in no time.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.