Maytag Appliance Parts

This is a genuine OEM part that works for some models of Whirlpool, Jenn-Air, Kenmore, KitchenAid, Maytag, Amana, Magic Chef, Admiral, Norge, and Roper models.

This SxS Refrigerator Defrost Thermostat is a safety device that clips onto the evaporator in the freezer. The Defrost Thermostat turns off the defrost heater in case it gets ...too warm in the freezer section. If your refrigerator does not defrost, replacing this part may alleviate the issue. Replacing this part will require basic hand tools, disassembly of the refrigerator and novice repair experience. You must unplug the refrigerator or shut off the house circuit breaker for the appliance before installing this part. Required Accessories: You will need two wire nuts to complete this repair. Helpful Tip: Take a digital photo of the shelf side rails before removing to aid with reinstallation.Part Specification• This product is a Factory Certified Part. These three words represent quality parts and accessories designed specifically for your appliance. Time tested engineering that meets our strict quality specifications• This product is a replacement part• Package contains (1) SxS Refrigerator Defrost Thermostat• Tools Needed: Multi screwdriver, needle-nose pliers, wire-splicing tool Read More Read Less

This Electric Range Oven Broil Element is a replacement part with 1/4" push-on wire terminals that provides constant heat to the broiler when cooking. If your broiler does not ... heat up properly, replacing this part may alleviate the issue. Reuse the existing support bracket for the element if your oven has one when installing this part. Replacing the element will require basic hand tools, some disassembly of the oven and novice repair experience. You must unplug the oven or shut off the house circuit breaker for the appliance before installing this part. Helpful Tip: Be mindful not to let the wires connected to the current part fall back inside the oven when you disconnect them; retrieval of the wires will require addition steps during installation, including removal of the rear panel of the appliance.Part Specification• This product is a Factory Certified Part. These three words represent quality parts and accessories designed specifically for your appliance. Time tested engineering that meets our strict quality specifications• This product is a replacement part• Package contains (1) Electric Range Oven Broil Element• Tools Needed: Multi screwdriver Read More Read Less

The Dryer Felt Seal encloses the drum in the appliance to prevent air from escaping during the drying cycle. If the seal in your dryer is worn out or damaged, you may notice t ...hat your dryer does not tumble properly. As the felt seal wears out and compresses over time, it can also cause hot air to escape the drum, making the drying cycle noisy and less effective. Required Accessory: You will need High Temperature Adhesive (item WPY055980) to complete this repair. Installing this part will require basic hand tools, some disassembly of the dryer and novice repair experience. You must unplug the dryer or shut off the house circuit breaker for the appliance before installing this part.Part Specification• This product is a Factory Certified Part. These three words represent quality parts and accessories designed specifically for your appliance. Time tested engineering that meets our strict quality specifications• This product is a replacement part• Package contains (1) Dryer Felt Seal• Tools Needed: Multi screwdriver, needle-nose pliers Read More Read Less

This is a genuine OEM part that works for some models of Whirlpool, Jenn-Air, Kenmore, KitchenAid, Maytag, Amana, Magic Chef, Admiral, Norge, and Roper models.

This Top Load Washer Water Inlet Valve Assembly lets the hot and cold water into your washing machine and distributes it around to the dispensers. If the valve is leaking or t ...he solenoids are damaged, this part will need to be replaced. Usually, a long or slow fill cycle is often due to a restricted water valve. Please note: The valve should never be disassembled and cleaned, only replaced. Replacing this part will require basic hand tools, some disassembly of the washer and novice repair experience. You must unplug the appliance or shut off the house circuit breaker for the appliance before installing this part. Also make sure you turn the water supply off to the water and place a towel down when removing the hot and cold fill hoses from the valve. Recommended Item: 10" V-Jaw Tongue & Groove Pliers (item 3527544) V-Jaw increases the number of contact points on the jaw to create a stronger grip. Helpful tip: Consider replacing the old fill hose when installing a new valve (item 1178857).Part Specification• This product is a Factory Certified Part. These three words represent quality parts and accessories designed specifically for your appliance. Time tested engineering that meets our strict quality specifications• This product is a replacement part• Package contains (1) Front Load Washer Water Inlet Valve• Tools Needed: Multi screwdriver, 10" V-Jaw Tongue & Groove Pliers, tape, putty knife, standard pliers, nylon lanyard Read More Read Less

This is a genuine OEM part that works for some models of Whirlpool, Jenn-Air, Kenmore, KitchenAid, Maytag, Amana, Magic Chef, Admiral, Norge, and Roper models.

The Dryer Lint Filter is a screen that provides proper air flow and operation of your dryer. The filter should be cleaned before every load of laundry and replaced immediately ... if damaged. If the existing part is damaged or missing, replacing this part may alleviate these issues. Quickly replacing your dryer’s lint filter is a quick and essential way to help keep your appliance operating at optimal levels. Replacing this part will require no disassembly or repair experience. Recommended Item: The universal Cleaning Brush (item 4210463RW) is useful to remove lint and other debris from the dryer’s venting.Part Specification• This product is a Factory Certified Part. These three words represent quality parts and accessories designed specifically for your appliance. Time tested engineering that meets our strict quality specifications• This product is a replacement part• Package contains (1) Dryer Lint Filter• No tools required for installation Read More Read Less

W11546610 is an original equipment manufactured (OEM) part. Ensure your refrigerator operates efficiently with this essential heating element, designed specifically for a vari ...ety of popular brands. This part is a reliable solution for maintaining optimal performance in your appliance while preventing frost buildup that can disrupt cooling. Made by Whirlpool, this heating element is compatible with Admiral, Amana, Jenn-Air, Kenmore, Kitchenaid, Magic Chef, Maytag, Norge, Roper, and Whirlpool refrigerators, making it a versatile choice for many models. Easy to install and built to last, it helps prolong the lifespan of your refrigerator, ensuring your food stays fresh and safe. Maintain your appliance with this high-quality heating element, and enjoy peace of mind knowing your refrigerator is equipped for reliable operation. Trust in a name known for quality and innovation in home appliances. Read More Read Less

The Bottom Freezer Refrigerator Toe Grille, Grey allows air to flow into the machine compartment to cool the condenser and prevents objects from entering the machine compartme ...nt. If the existing Grille is broken or cracked and will no longer attach to the appliance properly, replacing this part may alleviate the issue. This grey plastic part measures 36" L x 6-1/2" H and is designed to be used specifically with grey appliances. Installing this part will not require hand tools, disassembly or repair experience.Part Specification• This product is a Factory Certified Part. These three words represent quality parts and accessories designed specifically for your appliance. Time tested engineering that meets our strict quality specifications• This product is a replacement part• Package contains (1) Bottom Freezer Refrigerator Toe Grille, Grey• No tools required for installation Read More Read Less