W11256781 Whirlpool Lid

Step 1: Unplug the refrigerator from the power source.

Step 2: Remove the screws holding the back panel of the refrigerator in place, then lift and set aside the panel to expose the wiring.

Step 3: Disconnect the two wires connected to the lid switch that is located in the top left corner of the compartment.

Step 4: Take note of where each wire connects to the switch and which connector they are attached to.

Step 5: Remove any screws holding the switch in place and lift the switch out of the appliance.

Step 6: Insert the new Whirlpool W11256781 Lid Switch into the appliance.

Step 7: Fasten the switch into place with the screws previously removed.

Step 8: Connect the wires back onto the switch, in their original position, to the two connectors.

Step 9: Replace the back panel of the refrigerator and secure it in place with the screws.

Step 10: Plug the refrigerator back into the power source.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.